Innotox 50U

Innotox 50U is a botulinum toxin type A preparation from Medytox Inc., one of South Korea's largest and longest-running toxin manufacturers. What sets it apart from almost everything else on the market is the format: it arrives as a finished liquid solution rather than a freeze-dried powder. There is no saline to draw up, no vial to reconstitute, and no reconstitution maths to get wrong at the end of a long clinic day.

That single change removes a surprising amount of friction. Reconstitution is where most dosing inconsistency creeps in - a slightly different diluent volume between two practitioners means two different unit concentrations from the same product. With Innotox, the concentration is fixed at the factory, so what you draw is what the label says. It also cuts one full step of open-vial handling, which matters for sterility in a busy treatment room.

MY SKIN KOREA supplies Innotox 50U direct from Korea to licensed clinics and practitioners, shipped under temperature-controlled conditions.

Key features of Innotox 50U

Ready-to-use liquid formulation

Supplied pre-diluted at 4 units per 0.1 ml. No reconstitution, no diluent to stock, no variation between operators. Draw and inject.

Protein-free, albumin-free, gelatin-free

Innotox is stabilised with L-methionine and polysorbate 20 instead of human serum albumin or animal-derived gelatin. For practitioners whose patients ask about animal-derived components, this is the practical reason Innotox gets chosen over powder formulations such as Botulax 100U.

Controlled diffusion

The liquid formulation is associated with a tight, predictable spread from the injection point - useful in the periorbital region and anywhere a millimetre of unwanted diffusion changes the result.

Fast, low-discomfort application

A typical treatment runs 5 to 30 minutes depending on the number of areas. A 30G needle and the small injection volume mean most patients tolerate the procedure without topical anaesthetic, though many clinics still reach for a numbing cream on more sensitive areas.

Manufactured to Korean GMP standards

Produced by Medytox, a licensed Korean manufacturer with an established export record across Asia, South America and the Middle East.

Clinical applications

Aesthetic

• Glabellar (frown) lines
• Horizontal forehead lines
• Lateral canthal lines (crow's feet)
• Masseter reduction and lower-face contouring
• Bunny lines, chin dimpling, platysmal bands
• Axillary and palmar hyperhidrosis

Therapeutic

• Blepharospasm
• Cervical dystonia
• Paralytic strabismus
• Post-stroke upper and lower limb spasticity

Approved indications vary by country. Practitioners should treat within the scope of their local approval and their own clinical judgement.

Composition

Active ingredient

Clostridium botulinum toxin type A, Hall strain - 50 units per vial. It works by blocking acetylcholine release at the neuromuscular junction, producing temporary, reversible relaxation of the injected muscle.

Excipients

• L-methionine - antioxidant stabiliser, protects the toxin protein in solution
• Polysorbate 20 - surfactant, keeps the active ingredient evenly dispersed
• Buffered saline, pH 7.0 - solution vehicle

Innotox 50U specifications

Handling

Before you inject

Inspect the vial. The solution should be clear and colourless with no visible particles, and the vial itself should be intact. If anything looks off - cloudiness, discolouration, a compromised seal - do not use it.

Dosing

Innotox is supplied at 4 units per 0.1 ml. Dosing per site follows standard botulinum toxin type A practice; adjust for muscle mass, patient history and prior response, and refer to Medytox's prescribing information for the detail.

Aftercare

Advise patients to stay upright for around four hours, avoid rubbing or massaging treated areas, and skip strenuous exercise, saunas and alcohol for the rest of the day. Onset is typically visible from day 2 to 3, with full effect around day 7 to 14.

Safety notes

Botulinum toxin is a prescription-only product, to be administered only by appropriately qualified and licensed practitioners. Effects can spread beyond the injection site and, rarely, cause symptoms such as swallowing or breathing difficulty. It is contraindicated in pregnancy, breastfeeding, known hypersensitivity to any component, infection at the intended injection site, and neuromuscular disorders such as myasthenia gravis. Refer to the manufacturer's full prescribing information before use.

Innotox vs powder-form botulinum toxins

Duration of effect is broadly comparable to other botulinum toxin type A products - most patients see results lasting roughly three to six months, varying with dose, treatment area, muscle mass and individual metabolism. Patients treated repeatedly over time often report longer intervals between sessions.

If you get through more than a vial a session, Innotox 100U is the same solution at the same concentration in a larger fill, and works out cheaper per unit.

Storage and shipping

Innotox 50U must be kept between 2 °C and 8 °C at all times. We ship every order in insulated cold-chain packaging with coolant, and track transit so the product reaches you within its temperature range. Refrigerate on arrival. Do not freeze, and do not leave vials at room temperature for extended periods.

Buy Innotox 50U from MY SKIN KOREA

We source Innotox directly from Korean supply channels, so what arrives at your clinic is authentic Medytox product with genuine Korean packaging and a full remaining shelf life. Cold-chain shipping is standard, we deliver worldwide from Seoul, and pricing improves at clinic volumes - see wholesale for trade terms.

Browse the full botulinum toxin range, including Botulax 200U, Liztox 200U and Nabota 200U. Many clinics consolidate toxin with dermal fillers and skin boosters in one shipment to keep freight costs down.

Innotox 50U is intended for use by licensed medical professionals only. Availability and import rules differ by country - ask us about bulk pricing, lead times or documentation before you order.

Frequently asked questions

Does Innotox need to be reconstituted?

No. Innotox 50U comes as a ready-to-use liquid at 4 units per 0.1 ml. You draw the dose straight from the vial.

How long does Innotox 50U last?

Most patients see results for around three to six months. Duration depends on the dose used, the area treated, muscle bulk and how quickly the individual metabolises the toxin.

How many units are in one vial?

50 units in 1.25 ml of solution.

How soon do results appear?

Typically 2 to 3 days after injection, with the full effect settling in over 7 to 14 days.

Is Innotox animal-free?

Innotox is formulated without albumin or gelatin, using L-methionine and polysorbate 20 as stabilisers instead.

How should Innotox be stored?

At 2-8 °C, away from light. Never freeze it.

Who can buy Innotox 50U?

Innotox is a prescription-only product for licensed medical practitioners and clinics. Import and use requirements differ by country, so please confirm what applies where you practise.